Audio-technica FREEWAY ATW-701/H Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
4
R
eceiver Controls and Functions
(
Continued)
8
. UNBALANCED AUDIO OUTPUT JACK:
1
/
4
"
phone jack. Can
be connected to an unbalanced aux-level input of a mixer,
guitar amp or tape recorder.
9. AF LEVEL (VOLUME) CONTROL: Adjusts audio output level
of both AF Output jacks; maximum output is fully clockwise.
12
1
1
Figure C-Rear Panel Controls and Functions
10
9
8
10. BALANCED AUDIO OUTPUT JACK: XLRM-type connector.
A standard 2-conductor shielded cable can be used to
connect the receiver output to a balanced microphone-level
input on a mixer or integrated amplifier.
11. CORD HOOK: Loop the cord around the cord hook to keep
the DC plug from pulling out accidentally.
12. POWER INPUT JACK: Connect the DC plug from the included
in-line AC adapter.
Transmitter Setup, Controls and Functions
Figure D-UniPak Transmitter
Handheld Transmitter Battery Installation
4. Unscrew the lower body cover, slide it downward, and
remove it to expose the battery compartment.
5. Observe correct polarity as marked inside the battery
compartment and carefully insert two fresh 1.5V AA alkaline
batteries. Insert the first battery and slide it toward the
spring contact. Then insert the second battery into the
space remaining. Make certain the batteries are fully seated
in the battery compartment. (Fig. E)
6. Slide the lower body cover back on and screw the housing
together. Do not overtighten.
Note: Remove batteries from the handheld transmitter starting
at the bottom end, where finger indents in the battery housing
are provided for easy grip.
Figure E-Handheld Transmitter Battery Compartment
Screwdriver
Transmitter
Door Catch
Battery
Compartment
Transmitter
Door
Battery
Compartment
RF Power
Select
Switch
Screwdriver
Transmitter
Door
(Open
Positon)
Channel
Selector
Switch
Battery Selection
Two 1.5V AA alkaline batteries are recommended.
UniPak
®
Transmitter Battery Installation
1. Open the transmitter door by first pulling the catch down
and then sliding the door upward (Fig. D).
2. Observe correct polarity as marked and carefully insert two
fresh 1.5V AA alkaline batteries (Fig. D).
3. Slide the door closed, making certain it clicks securely in
place.
Vue de la page 3
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire